Gelişmiş Arama

Basit öğe kaydını göster

dc.contributor.authorYazman, Şakir
dc.contributor.authorKöklü, Uğur
dc.contributor.authorUrtekin, Levent
dc.contributor.authorMorkavuk, Sezer
dc.contributor.authorGemi, Lokman
dc.date.accessioned2022-11-16T08:20:35Z
dc.date.available2022-11-16T08:20:35Z
dc.date.issued2020en_US
dc.identifier.citationYazman, Ş., Köklü, U., Urtekin, L., Morkavuk, S., & Gemi, L. (2020). Experimental study on the effects of cold chamber die casting parameters on high-speed drilling machinability of casted AZ91 alloy. Journal of Manufacturing Processes, 57, 136-152.en_US
dc.identifier.issn15266125
dc.identifier.urihttps://doi.org/10.1016/j.jmapro.2020.05.050
dc.identifier.urihttps://hdl.handle.net/20.500.12513/4736
dc.description.abstractIn this study, the effects of the cold chamber die casting parameters on high-speed drilling machinability of AZ91 Magnesium alloys were experimentally investigated. The influence of different casting parameters (casting temperature, molding pressure, and gate speed) on microstructure, mechanical properties and machinability characteristics (thrust force, tool wear, built-up edge, built-up layer formation, surface topography, chip morphology, and burr formation) were examined. The experimental results showed that the grain size of the conventional casting sample was around 50 microns, while in other cold chamber die casting tests, it varied depending on temperature, pressure, and gate speed. It was observed that the tensile strength values ​​of the samples produced with 1000 bar mold pressure were higher than those of other samples. In the formation of thrust force, the feed rate is more effective than the cutting speed. The least tool wear occurred in the drilling of the As-cast sample, while the highest tool wear occurred in the drilling of the sample which was produced with low pressure and low gate speed combination. As a result of the drilling tests, depending on casting and cutting parameters, three different types of chips were formed: fan, spiral cone, and long ribbon type. Furthermore, uniform and transient burrs in different sizes were observed. © 2020 The Society of Manufacturing Engineersen_US
dc.language.isoengen_US
dc.publisherElsevier Ltden_US
dc.relation.isversionof10.1016/j.jmapro.2020.05.050en_US
dc.rightsinfo:eu-repo/semantics/openAccessen_US
dc.subjectAZ91en_US
dc.subjectBurren_US
dc.subjectChipen_US
dc.subjectCold chamber die castingen_US
dc.subjectHigh-speed drillingen_US
dc.subjectThrust forceen_US
dc.subjectTool wearen_US
dc.titleExperimental study on the effects of cold chamber die casting parameters on high-speed drilling machinability of casted AZ91 alloyen_US
dc.typearticleen_US
dc.relation.journalJournal of Manufacturing Processesen_US
dc.contributor.departmentMühendislik-Mimarlık Fakültesien_US
dc.contributor.authorIDLevent Urtekin / 0000-0003-4348-4749en_US
dc.identifier.volume57en_US
dc.identifier.startpage136en_US
dc.identifier.endpage152en_US
dc.relation.publicationcategoryMakale - Uluslararası Hakemli Dergi - Kurum Öğretim Elemanıen_US


Bu öğenin dosyaları:

Thumbnail

Bu öğe aşağıdaki koleksiyon(lar)da görünmektedir.

Basit öğe kaydını göster